Wire Strength Requirements: Minimum Allowable Section of Wire Core for Indoor Wiring

 

 

 

當用電負荷太小時，如果按照上節課中提到的按允許載流量計算選擇的導線，其截面也太小，當導電線太細的時候往往不能滿足足夠的機械強度要求，這就容易發生斷線事故。

 

When the electric load is too small, if the conductor selected according to the allowable carrying capacity calculation mentioned in the last lesson is too small, when the conductor is too thin, it often can not meet enough mechanical strength requirements, which is prone to wire breakage.

 

 

 

因此，對于室內配線電線的線芯的最小允許截面有專門的規定，并且：當按照允許載流量選擇的導線截面小于下表中的規定時，應按照最小允許截面來選擇。室內配線電線線芯最小允許截面要求：

 

Therefore, there are special provisions for the minimum allowable cross-section of the core of indoor wiring, and when the conductor cross-section selected according to the allowable carrying capacity is less than the stipulation in the table below, the minimum allowable cross-section should be selected according to the minimum allowable cross-section. Minimum allowable cross section requirement for indoor wiring cores:

 

 

 

室內配線電線線芯最小允許截面規定要

 

Minimum Allowable Section of Wire Core for Indoor Wiring